ETEPON Digital Oscilloscope Kit
【Assembled Finished & Handheld】 ETEPON digital oscilloscope kit is NOT DIY PART. It can be used directly to avoid assembling welding process problems and greatly saves the assembly time.
【Updated Sensitivity The sensitivity of oscilloscope has been extended in both directions and is higher and wider. It reaches 5mV/div -- 20V/div.
【Rotary Encoder It has been added rotary encoder, makes parameter adjustment more quicker and easier.
【More Updated Design Display and MCU are mounted on the same board (mainboard) to avoid using inter-board pin-headers. Analog channel is placed on a separated board which contains most user install parts, so the analog and digital circuits can be better separated.
【Package Included】1* Oscilloscope, 1* BNC-clip cable, 1* User Manual (Detailed Operation instructions, troubleshooting guide and schematic are included).
EM001 oscilloscope kit is a complete set-up, machine, which can be used directly.
✔ Extended Size in both width and height
✔ held in your hand
✔ added the rotary encoder and makes quick and easy adjustment of parameters.
✔ recording you lightning-fast waveforms easy to stand up with the car/Normal/Single Trigger Mode.
The screen and the MCU are on the same board (Motherboard) Assembled, to spaces to avoid Nplatinen - Straight Pin Headers. The analogue channel is located on a separate board, the most fillers for the user installation contains that fresh air can be provided for the analogue and digital circuits can be better separated. Specification
Number of channel: 1
Analog bandwidth: 0 - 200KHz
Sensitivity: 5mV/div - 20 V/DIV
Sensitivity errors: < 5%
Resolution: 12 bit
Input Impedance: 1 M ohms
Maximum input voltage: 50Vpk
Coupling: DC, AC, GND
Trigger mode: Auto, Normal and Single
Trigger Type: Rising, Falling edge
Trigger position: 1/2 of the buffer size set
Display: 2.4 inch colour TFT LCD with 320 H ） × 240 （ V ） Resolution
Power supply: 9 V DC (8 - 10 V bumping), not included).
Dimensions: 115 x 75 x 22 mm
Weight: 100 g (without cables and power supply)
1 * shell oscilloscope
1 * BNC clip cable
1 * User Manual
1) shell runs on 9 V power supply. The supply voltage must not exceed 10 V. Otherwise, it is possible the machine auszubrennen. DC 9 V supply should be positive in the middle.
2) the kit does not contain power adapter, it is relatively simple, a. Please Bereite dich.